This topic contains 3 replies, has 3 voices, and was last updated by  nightflier51 2 months ago.

  • Author
    Posts
  • #29219

    sroberti
    Participant

    I have a USA 3 bell that’s 18.5 in diameter doesn’t have the upright. I’ve located a American Casting Co Birmingham AL 3 upright. I think it will work based on measurement but I’m not 100%. First question is are all #3 bells the same. Second question…who made the “USA” bell?

  • #29222

    sroberti
    Participant

    Here’s a picture of the bell.

  • #29242

    DavidE
    Keymaster

    No picture showing unfortunately.

    Please note that max file size is 1024KB
    If you need to resize, please see How to use the Bell Talk forums/Resize photos.

    Thanks
    David

  • #29254

    nightflier51
    Participant

    I was told thise USA bells were made in a foundry in Alabama in the 70s and 80s. They made a lot of them..They used the Ross Meehan type cranks but looked a lot like CS Bells of Ohio firm. They use to be plentiful but getting more scarce every day….

You must be logged in to reply to this topic.